Frequently Asked Questions

The “auto” position is the most energy efficient position for your air conditioning and heating system because the fan will run only when the temperature requires it. There are additional benefits of the “auto” setting that include that the air within the home constantly being circulated resulting in an even temperature throughout the house. Unlike the “auto” setting, the “on” setting position will cause the humidity to be higher. This will result in the dry and sticky air we all dread in Dallas.

As of 2010 air conditioning and heating systems being installed were still using the most common R-22 refrigerant. However, as of the end of 2010, air conditioning and heating systems will longer be manufactured using R-22 refrigerant. The new R-410a refrigerant will take its place. Because R-410a has zero ozone depletion it is much better for our environment. If you have an air conditioning system that uses R-22 you can have peace mind that small quantities of R-22 will continue to be produced until 2020.

Your air conditioning system distributes cool air throughout your home and releases the heat outdoors. A heat pump has the ability to reverse the flow of the refrigerant and release the warm air into your duct system where it will also extract the heat from the outdoors. Installing a heat pump can be an extremely economical choice for the winter months because it will reduce the amount of electricity being used to generate heat during colder weather.

It is normal for a heat pump to build ice on the coils during the winter months. Within a couple of hours the frost will automatically thaw and the system will go into defrost mode. If the frost does not melt after a few hours you may have a problem with the defrost cycle and you should call Nick’s Air Services for immediate service.

In able to achieve maximum efficiency of the unit you are purchasing it is suggested that you replace both the condenser and the air handler at the same time. In addition, you should also know that some warranties will not be completely covered with a “mixed” system.

Yes, purchasing a new 13 SEER or higher air conditioner could save you as much as 50% on your electric bills. 13 SEER is currently the minimum efficiency standard required by the EPA and depending on your current air conditioning and heating system you could save even more.

In able to help consumers make informed choices, the U.S. Department of Energy requires an efficiency rating of all air conditioning and heating equipment. These ratings are intended to reflect how much energy is being utilized. The higher the rating, the higher the efficiency for a particular unit. Air conditioning equipment is rated by the Seasonal Energy Efficiency Rating, or SEER. Heat pump equipment is rated by the Heating Seasonal Performance Factor, or HSPF. Gas furnaces are rated by their Annual Fuel Utilization Efficiency, or AFUE.

If there are rooms in your home that you use more than others a zoned air conditioning and heating system provides the power of controlling areas of your home individually separate areas with a with a single system and dedicated thermostats. Zoning allows you to conserve energy and increase comfort.

In able to ensure the efficiency of your HVAC system, extend the systems’s life and prevent major repairs, your air conditioning and heating system should receive a comprehensive preventative maintenance checkup at least twice a year. At Nick’s Air Services, we offer preventative maintenance agreements that provide you peace of mind year-round. Our maintenance also gives you discounts on needed service and priority attention when you need us the most. To learn further about our maintenance plan, please tour the preventative maintenance page of this site or contact us at 214-900-6096.